E-flite 60-Amp Pro Switch-Mode BEC Brushless ESC


Omadused:
Up to 60-amp continuous current with proper air flow, 75-amp peak
5-volt Switch-Mode BEC circuit capable of 2.5-amp continuous current on any recommended input voltage
Drives up to 7 analog or 6 digital standard-sized servos, with the BEC on any recommended input voltage
3–6S Li-Po, 9- to 18-cell Ni-Cd/Ni-MH input voltage
Finned heat sinks
Programmable motor braking
Safe power-arm mode prevents accidental starts
Programmable low voltage cutoff with settings for 3-cell Li-Po (9V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V), or 70% of battery starting voltage
Programmable soft start for helis and airplanes
Auto motor shut down if signal is lost or there is interference
Programmable timing—5 user-selectable ranges for use with a larger variety of brushless motors
Programmable throttle input range (1.1–1.9 ms or 1.2–1.8 ms)
Utilizes new smaller MOSFETs technology to minimize weight
Radio System Power On/Off Switch
Optional RS232 Serial Link available for programming
Pre-wired connectors—E-flite EC3 on battery input and 3.5mm female gold bullets on motor output leads

Tehnilised andmed:
Brake: Yes - Programmable
Continuous Maximum Current: 60A with reasonable cooling
Input Voltage: 10.8V - 22.2V
Input Connector Types: 13AWG with E-flite EC3 connector
Output Connector Types: 13AWG with 3.5mm Female Gold Bullet Connectors
Momentary Peak Current: 75A (15 sec)
Length: 76mm
Width: 33mm
Height: 13mm
Weight: 66g
Wire Gauge: 13AWG
Cells w/BEC: 3-6S Li-Po or 9-18 Ni-MH/Ni-Cd